Vanagon 2WD L4-2109cc 2.1L (1986)
Drive Belt: All Technical Service Bulletins
Tools - Three Groove Pulley Removal
Applies
VANAGON
2.1L
1986
Group
13
Subject
Retainer Tool 3149
Part Identifier 1376
Key Points
Removal of three groove pulley
B 016
Number
86-01
April 18, 1986
Retainer tool 3149 is required to hold crankshaft from rotating while removing/installing the three groove pulley.
It consists of three separate pieces:
^
alignment plate
^
pad
^
socket and handle
Work sequence
-
loosen power steering pump, if applicable, remove V-belt from crankshaft pulley
-
loosen A/C compressor, if applicable, remove V-belt from crankshaft pulley
-
loosen alternator, remove V-belt from crankshaft pulley
-
unscrew coolant expansion tank, lay to one side
-
remove expansion tank bracket
-
remove retaining screws and bolts from exhaust heat shield
-
reposition heat shield down and under its original position
Note
When tool 3149 is used, it will not be necessary to remove muffler.
-
rotate pulley so both alignment holes are horizontal
-
insert alignment plate into pulley
