Vanagon Syncro AWD F4-2109cc 2.1L (MV) (1989)
Interior Moulding / Trim: All Technical Service Bulletins
Interior Trim - Dirty/Soiled
Group: 70
Number: 93-04
Date: November 15, 1993
Subject:
Interior fabrics, vinyls and plastics, cleaning
Model(s):
All models
All m.y.
Condition
Interior trim panels, seat upholstery, plastic trim or vinyl dirty/soiled.
Service
If vehicles are received with dirty/soiled interior components, the original appearance of these components can be restored as follows:
CAUTION
Before using any chemicals or cleaning compounds, carefully read all of the cautions and medical information on the container.
The cleaning steps below MUST be followed IN SEQUENCE:
-
Identify all areas which need to be cleaned
-
Prepare cleaning solution:
^
Autobahn All Purpose Cleaner Concentrate, Part No. ZVW 243 101, diluted with water
^
dilution ratio:
1 part cleaner to 5 parts water
Note
For spot removal of heavy grease stains, etc., a mixing ratio of 1 part cleaner to 2 pails water can be used.
-
Apply cleaner/water solution to soiled area with a hand spray bottle. The nozzle must be adjusted to produce a fine mist.
-
Using a clean soft towel, gently agitate solution in small circular motions until soiled area is clean. A small soft bristle brush may be used for
agitating cleaner solution in hard to reach areas.
-
Remove cleaner residue using a second spray bottle filled with clean water. Spray cleaned area, then dry with a clean soft towel.
-
Carefully inspect cleaned area. Repeat procedure as required.
Note
Water marks/rings visible after drying may be due to local tap water pH level. Repeat the procedure using bottled water.
If a trim panel or seat cover, for example, cannot be cleaned to an "as new" appearance, you may elect to replace that part and claim the repair in the
usual manner.