Vanagon Syncro AWD F4-2109cc 2.1L (MV) (1989)
Caution: Always remove stub axle with mechanical or hydraulic hub puller only. Do not heat up wheel bearing housing or wheel bearing
will be damaged.
Installing
Caution: Splines on drive shaft and wheel hub must be free of oil, grease and old locking compound.
-
apply locking compound D6 around splines of outer CV joint in a bead approximately 20 mm (25/32 in.) wide
Reminder of installation procedure is the reverse of removal.
Note: Allow locking compound D6 at least 60 minutes to harden before driving vehicle.
Wheel Bearing/Hub R&R (Front)
Wheel Bearing/Hub
Removal and Installing