Vanagon Syncro AWD F4-2109cc 2.1L (MV) (1989)
Shifter M/T: Technical Service Bulletins
M/T - Revised Shift Lever Bearing/Adjustment
SUBJECT:
Revised shift lever bearing
GROUP
34
NUMBER
89-03
February 28, 1989
MODEL(S):
Vanagon, all with Man. Trans.
Beginning with 06/88 production, the centering holes (arrows) in the shift lever bearing have been deleted.
Revised shift lever bearing, adjusting
^
loosen nuts (not shown)
^
turn shift lever bearing to right or left until mounting studs contact ends of slots in bearing (arrows)
^
tighten nuts to 10 N-m (7 ft.lbs.)
Further adjustment of the gearshift lever is to be conducted as described in the repair manual.
Note
The revised shift lever bearing can be installed in vehicles beginning with 10/82 production.