Vanagon Syncro AWD L4-2109cc 2.1L (1987)
-
remove bolt A from differential lock servo
-
loosen bolt B and withdraw as far as possible (clearance limitations prevent complete removal of bolt B)
CAUTION
Nuts C and D are welded to the bracket.. No attempt should be made to loosen them.
-
push back protective sleeve and drive out roll pin
-
with bolt B withdrawn as far as possible, give servo a slight upward twist and remove from bracket
-
remove circlip 1
-
remove bolts (arrows)
-
remove bracket
Starter motor, removing
-
disconnect wires from solenoid terminals 30 and 50