240 L4-2.3L SOHC VIN 88 B230F (1986)
- soundproofing and center console side panel on right side
B3
Release mounting bracket and valve
- Disconnect support (D) from mounting bracket (C) by loosening bolt (A) and removing bolt (B).
- Bend mounting bracket (C) 900 to left.
- Bend the two stops (E) downward and pull mounting bracket (F) and valve 30 mm to left.
B4
Disconnect control cable from valve Remove:
- clip (A) securing cable sleeve. Pull gently towards left sufficiently to free cable from valve control arm.
Caution:
Control arm is easily broken and must be treated with extreme care.
- valve, by clamping hose from heater with hose clamp tool and undoing hose clamps.
B5
Attach cable to new valve
Insert:
- wire in hole in valve control arm.
Adjust position of cable in clip (A) so that valve opens fully when control lever is set to maximum and closes fully when control lever is set to minimum.
Caution: Control arm is easily broken and must be treated with extreme care.
B6
Assembly of mounting bracket, hose, valve, plastic foam packing and hose retainer.
