240 L4-2.3L SOHC VIN 88 B230F (1986)
A10
Lubricate mainshaft and install synchronizer
Turn hub so that groove for brass ring is facing 1st gear.
Do not install brass ring at this stage.
A11
Check position of synchronizing ring.
Use 2852 to support shaft. Install snap ring.
REPLACING BUSHING WITH NEEDLE BEARING 1st GEAR
A12
Press off bushing from 1st gear
Use 5242 (rear axle special tool) to support shaft. Press bushing off with 5080
A13
