240 L4-2.3L SOHC VIN 88 B230F (1986)
5. Position the drive flange on the output shaft.
6. Install washer and nut. Use wrench P/N 5149 to hold the drive flange while torquing the nut. Torque to 165-18O Nm (120-13O ft lb).
7. Install speedometer gear assembly. Torque bolt to 4-6 Nm (3-4 ft lb).
One-way-clutch
NOTE: Always use the new type hub with high cams, see illustration. Check the roller cage for damages and wear. Replace as necessary.
1. To assemble, install the spring in the holes in the cage.
