240 L4-2127cc 2.1L SOHC B21F (1982)
Install:
-
shims. Ensure that the shims are reinstalled on the shaft in the same order as they were removed.
-
clutch plate on compressor shaft, if necessary use puller 999 5598-1 ans sleeve 9995601-3.
-
screw and washer or nut.
Tighten to 15 Nm (11 ft. lbs).
Use counterhold 999 5596-5.
Check Clearance/Finishing Work
Run a feeler gauge all the way around in the gap. Clearance should be between 0.3 and 0.5 mm. 0.3 mm should pass all around the gap.
If the clearance is not between the given values, use shims to adjust clearance until it does.
Shims are available in the following dimensions:
^
0.2 mm
^
0.3 mm
