240 L4-2127cc 2.1L SOHC B21A (Can) (1984)
1. Jack up rear end.
2. Unload the overdrive:
-
Start engine and engage overdrive.
-
Depress the clutch pedal and switch off the engine.
3. Disconnect the drive shaft at the overdrive flange.
4. Disconnect the speedometer cable at the overdrive.
5. Disconnect the solenoid ground wire.
6. Have an oil collecting pan ready. Remove the nuts retaining the overdrive housings. Remove the spring washers and the seals at the two upper
studs.
7. Remove overdrive rear housing. Clamp it in a vise with soft jaws.