240 L4-2127cc 2.1L SOHC Turbo B21FT FI (1982)
Bend mounting bracket (B), 900 to left. Route cable between heater housing and radio compartment, and through hole (C) in heater mounting bracket.
A6
Install new control cable
Attach:
- cable to control lever
Adjust position of cable in clip so that valve opens fully when control lever is set to maximum and closes fully when control lever is set to minimum.
A7
ASSEMBLY OF MOUNTING BRACKET, HOSE, VALVE, PLASTIC FOAM PACKING AND HOSE RETAINER
Install/connect:
- plastic foam packing (A) and hose retainer (B) in bracket with screw.
- hose from heater to valve. Tighten hose clamp.
- secure hose in retainer.
- close valve and remove hose clamping tool.
Note:
Valve must be closed or coolant will leak from heater.
A8
Install mounting bracket and valve