240 L4-2127cc 2.1L SOHC Turbo B21FT FI (1982)
Coolant Pump: Service and Repair
Removal
WATER PUMP REPLACEMENT
NOTE: Replacement of water pump, rubber seals or gasket must always be preceded by pressure testing the cooling system. Water pumps are often
changed unnecessarily, for example when only a gasket is leaking. In the case of a leakage, the system should therefore be pressure tested in
order to establish whether there is a leakage, and to avoid unnecessary pump replacement.
Changed Mounting Bolt For Return Pipe
CAUTION: The hexagonal bolt has been replaced by a different bolt, PIN. 942247-8. This has been done to make it easier to remove/install the bolt on
engines with Pulsair system.
Coolant Drain & Fill Locations
Drain Coolant:
1. Move dashboard heater control to maximum warm.
2. Remove expansion tank cap.
3. Open the drain cock on right side of cylinder block.
4. Disconnect lower hose from radiator.