240 L4-2127cc 2.1L SOHC Turbo B21FT FI (1982)
-
Remove bolt, washer and nut.
NOTE:Removing hexagonal bolt on engines with Pulsair system. There are two different methods for removing the old hexagonal bolt:
Cars without block heaters:
-
Remove the rear mounting bolt of the return pipe (rear edge of cylinder block). Loosen and pull the coolant pump out slightly. Remove the
bolt.
Cars with block heaters:
-
Drill away the head of the bolt (drill 0 8 mml.
2. Remove all bolts, washers and nuts.
Water Pump To Block Surface
Clean Gasket Surface And Contact Surfaces:
1. Scrape off any traces of gasket material from block and water pump.
2. Clean rubber ring contact area on cylinder head.