240 L4-2127cc 2.1L SOHC Turbo B21FT FI (1982)
4. Using pliers, remove hydraulic pistons.
5. Install new hydraulic pistons and O-rings.
6. Install pressure plates, using new nuts. Torque nuts alternately and evenly to 10 Nm (7.5 ft lb).
7. Install overdrive unit.
Removal
CAUTION:
^
It is important to avoid torsional stresses in the shaft between the planetary gear carrier and the one-way clutch.
^
Prior to removing the overdrive, it is advisable to drive the vehicle with the overdrive engaged and then disengage with the clutch depressed.
^
If this is forgotten, or not possible, the torsional stresses can be removed by engaging/disengaging the overdrive in vehicle. This can be
accomplished by connecting an oil line under 2.0-2.5 MPa (280-35O psi) pressure to the connection for the pressure gauge. With this pressure
connected, the overdrive can be engaged/disengaged by switching on ignition and the overdrive switch.
1. Disconnect the drive shaft from the overdrive flange.
2. Position a support under the engine.
3. Remove the cross member under the transmission.
4. Lower the engine rear end.
5. Disconnect the wires at the solenoid.