240 L4-2320cc 2.3L SOHC B23F FI (1983)
The oil level should be up to the filler plug hole. Transmission and overdrive are lubricated by the same oil. When oil is drained from transmission, also
remove cover on overdrive and clean strainer.
Replacing Oil Seal at Output Shaft
1. Disconnect the drive shaft at the overdrive flange.
2. Remove the nut. Use puller P/N 2261 to pull the drive flange.
3. Use extractor P/N 5069 to remove the oil seal.
4. Use drift P/N 2412 to install the new seal.
5. Use press tool P/N 1845 to install the drive flange.
6. Install drive flange nut. Torque to 165-180 Nm (12O-130 ft lb).
7. Reconnect the drive shaft.
Replacing One-Way Clutch
