240 L4-2320cc 2.3L SOHC VIN 83 B230FD (1993)
Oil Seal Installation
3. Clean and check sealing surfaces in holder and on crankshaft.
4. Press seal into rear sealing flange
-
Assemble standard handle 1801 and drift 5276.
-
Oil sealing lips and contact face of seal against holder.
-
Install seal on drift.
NOTE: If there is a wear surface on crankshaft, press seal further into flange than before.
-
Remove one spacer ring from drift if old seal was flush with flange.
-
Remove two spacer rings from drift if oil seal was 3 mm (0.12 in) inside flange.
-
Leave both spacer rings in drift if crankshaft is undamaged.
5. Tap in seal until drift contacts crankshaft.
Flywheel/Drive Plate Installation
