240 L4-2320cc 2.3L SOHC VIN 83 B230FD (1993)
- Press the button twice (for about 1 second each time). The LED begins to flash rapidly when DTM 2 is activated.
Activate the sensor to be tested following the ~Design and function, On-board diagnostic (OBD) system" section.
If the LED still flashes rapidly when the sensor has been activated:
-The control module has not received a signal from the sensor.
Exit DTM 2
- Switch off the ignition.
CB6
Diagnostic Test Mode (DTM) 3
Entering Control Function #3
- Press the button three times (for about 1 second each time). The control module activates the control components in the order indicated in the "Design
and function, On-board diagnostic (OBD) system" section. Activation is carried out three times.
- Listen to see if the component is activated.
If the component is not activated:
-The component is not receiving a signal from the control module.
Exit DTM 3
- Switch off the ignition.
