240 L4-2320cc 2.3L SOHC VIN 83 B230FD (1993)
Removing Protective Sleeve
5.
Remove connector protective sleeve.
IMPORTANT:^ Never check connections from the front. Connectors can get damaged and worsen the problem.
^ Check connections through the holes in the connector.
^ Connection pin numbers are printed on the connector side.
Checking Pin 35
6.
Turn ignition ON.
7.
Connect a voltmeter between pin 35 at ECU connector and ground (checking ignition switch).
8.
Check voltage.
Reading: approx. 12 volts
If not, check wiring and connectors. If no fault found, replace ignition switch and retest.
9.
Crank starter motor.
Reading: approx 12 volts
If not, check wiring and connectors. If no fault found, replace ignition switch and retest.
10.
Turn ignition OFF.
11.
After testing, disconnect all test equipment, reconnect all connectors (including the ECU connector) and remount all panels.