240 L4-2320cc 2.3L SOHC VIN 83 B230FD (1993)
Clamp the cable to the pressure sensor cable with a cable tie P/N 948211-8 to the existing cable harness.
Insert a cable tie through the hole in the firewall and in to the car. Tape cable to the cable tie and pull cable in to the car.
Make a hole in the rubber plug.
NOTE!
The hole should not be larger than the cable to ensure a tight fit through the plug.
Grease the cable terminal and the end of the cable with low temperature grease P/N 1161437-7. Insert the cable terminal and cable in the rubber plug.
Reinstall the rubber plug in the firewall.
Remove the protective cover from the connector.
Remove the tape over the protective cover. Remove the screw and pull off the protective cover.