240 L4-2320cc 2.3L SOHC VIN 83 B230FD (1993)
Place the MFI control module upside down on the static dissipation mat. Using a small screwdriver, open the MFI control module by bending the tabs
up. Fully open them with pliers. All tools must be ESD approved.
Turn the MFI control module over so that the cover is up. Place the MFI control module so the connector is away from you. Carefully lift the cover so
that it does not come in contact with the components on the circuit board.
Remove the EPROM cover Insert a small screwdriver (ESD approved) in each slot on the cover and pry carefully.
When it is loose, lift it.
Mark the EPROM with the "scrap" sticker provided in the kit (so that it will not be re-installed in error).