240 L4-2320cc 2.3L SOHC VIN 83 B230FD (1993)
Throttle Position Switch: Adjustments
WC. ADJUSTING THE THROTTLE POSITION (TP) SWITCH (LH 2.4 ONLY)
WC1
Adjusting The Throttle Position (TP) Switch
Turn the TP switch anti-clockwise until it clicks and then continue turning until it stops but no further. The throttle should not start to open, so hold it
closed with a finger on the throttle disc. Hold the TP switch in this position and tighten the TP switch screws (1.6 Nm.)
WC2
Checking
-Open the throttle and check the gap between the throttle lever and adjustment screw with a feeler gauge.
With a 0.45 mm feeler gauge there should be no click from the idle switch when the throttle is closed.
With a 0.15 mm feeler gauge there should be a click from the idle switch when the throttle is closed.
-Connect TP switch connector.
-Continue with WD. Adjusting throttle mechanism.
