740 L4-2.3L SOHC VIN 88 B230F (1985)
L10. Slacken hub nut half a turn
Tighten nut to 1.5 Nm (1.1 ft. lbs.) i.e. finger-tighten. Install new split pin. If pin hole is not opposite opening in nut, tighten nut further until pin
fits in next hole.
Install grease cup using socket 999 2715.
L11. Cars with ABS only:
Remove dirt from sensor and sensor wheel with soft brush.
L12. Install brake disc
Ensure that mating surfaces on hub and disc are clean.
Install disc with marking as close to hub marking as permitted by wheel studs.
Insert locating pin and tighten to 8 Nm (6 ft. lbs.).
For confirming accepted disc runout check according to regular procedures.
L13. Install brake caliper
Use new bolts. Tighten to 100 Nm (74 ft. lbs.).
