740 L4-2.3L SOHC VIN 88 B230F (1985)
11. Assemble blower motor, cover rubber gasket (A). Install foam rubber seal around drain pipe (B).
12. Install blower motor in heather housing. Tighten screws (three).
13. Install new connector:
-
Cut cable terminals off existing wiring.
-
Fit two cable terminals, Part Number 979003-1. Press cable terminals onto connector with (SB-W) connected to thinner lead (position 2).
-
Connect wiring harness (A) between motor and wiring harness in car.
-
Reconnect battery ground lead. Test operation.
14. Start blower motor. Use hand to feel around adapter ring for air leakage. If leakage is present, seal with butyl tape.
