740 L4-2.3L SOHC VIN 88 B230F (1985)
Power Steering Pump: All Technical Service Bulletins
Power Steering Pump - Pulley Transfer to New Unit
SECTION
GROUP
NO.
64
6
DATE MARCH, 1985
RE:
NEW SAGINAW POWER STEERING PUMP
P70 (B230)
THIS BULLETIN IS APPLICABLE TO BOTH THE U.S. AND CANADIAN MARKETS, AND SUPERSEDES SERVICE BULLETIN GROUP 64
NO. 6 (P70), DATED FEBRUARY, 1985
REPLACING SAGINAW TC POWER STEERING PUMP ON 740,760 MODELS WITH B230
New Saginaw power steering pumps are supplied without a pulley. It is, therefore, necessary to transfer the old pulley to the new pump when fitting a
new pump.
METHOD
DETACH BELT ADJUSTER AND LIFT OFF BELT
Place a rag beneath pump in case of spillage.
DISCONNECT HOSES FROM PUMP
Attach crimping pliers to hoses from pump reservoir.
REMOVE PUMP FROM ENGINE
REMOVE PULLEY
Use puller 9995259-0 and bolt 3/8" x 2 3/4" UNC.
