760 L4-2320cc 2.3L SOHC Turbo B23FT (1984)
Remove bearing and locking ring
-
Use press tool 5212.
-
Slide seal and pressure plate upwards until divided press plate can be placed on bearing.
-
Place press yoke over press plate.
NOTE: Opening in press plate must be positioned at 90 degrees to opening in yoke.
1 = Press yoke
2 = Divided press plate
3 = Counterhold
Grease new bearing before placing on drive shaft
-
Pack space between inner and outer races with grease.
-
Continue until grease emerges from opposite side of bearing.
NOTE: It is extremely important that bearing be completely packed with grease.
Grease new seals, both Inner and outer
-
Pack space between seal lips with grease.
Press bearing onto shaft
-
Place pressure plate and seal in correct position on shaft.
-
Place greased bearing and new locking ring on shaft.
-
Position ring 5242 over bearing and locking ring.
-
Place drive shaft in press.
-
Support ring 5010 on two V-blocks.
-
Press shaft until bearing and locking ring are seated in position.
-
Use handle 1801.