760 L6-2383cc 2.4L DSL Turbo D24T (1983)
Route the cable from the contact reel through the hole in the steering wheel.
Position the steering wheel so that the contact reel locking pin is in the center of the hole in the steering wheel.
Install screw holding steering wheel and finger tighten. Remove locking screw from the plastic strip.
Check that the steering wheel is straight: Drive the car straight ahead on a flat surface.
If the steering wheel is off-center:
Install the locking screw again.
Remove the steering wheel.
Turn the wheels a little (from outside) so that the steering column is in the correct position.
Install steering wheel.
When the steering wheel is straight.
Remove screw in plastic strip from pin and install in parking hole in the steering wheel.
Tighten screw holding steering wheel.
Tighten to = 33 Nm.
Rest lower part of steering wheel airbag module on steering wheel.
Connect connector.
Fold in steering wheel airbag module and screw into place from behind (2 x torx).
