760 L6-2383cc 2.4L DSL Turbo D24T (1983)
M2. Remove brake pads Remove lower bolt and raise piston housing.
M3. Remove:
^
brake caliper. Use 10 mm Allen key. Place caliper on support arm, ensuring that brake hose is not damaged.
^
guide pin
^
brake disc
M4. Check that hub flange is clean. Remove grit, oxidation, etc. with scraper blade and steel brush
If hub is marked, proceed to operations M - M14.
If hub is not marked as described, proceed to operation M5.
M5. Mount gauge ring 999 5419
Ensure that mating surfaces of hub and gauge ring are absolutely clean.
Mount gauge ring 999 5419 (from tool kit 999 5418) on hub. Tighten nuts diagonally to 85 Nm (63 ft. lbs.).
