760 L6-2383cc 2.4L DSL Turbo D24T (1983)
Control Module HVAC: Service and Repair
Programmer, Climate Control
NOTE:
^ Under no circumstances should the factory adjusted calibration screw on 760 A.C.C. programmers be altered. All programmers are factory calibrated
and do not need to be altered.
^ If a problem is encountered with a programmer, it must be returned under warranty. Altering the calibration will not correct any malfunction.
^ Programmers which have been adjusted by dealers will not be accepted under warranty.
Programmer Removal:
1. Remove panel below glovebox.
2. Remove glovebox.
3. Remove outer panel vents and ducts.
4. Disconnect air-mix shutter control rod from programmer.
5. Disconnect connector from left side of programmer.
6. Disconnect 3-pole connector (not shown).
7. Remove retaining clips from vacuum connection.