760 L6-2383cc 2.4L DSL Turbo D24T (1983)
12. Install blower motor in heather housing. Tighten screws (three).
13. Install new connector:
-
Cut cable terminals off existing wiring.
-
Fit two cable terminals, Part Number 979003-1. Press cable terminals onto connector with (SB-W) connected to thinner lead (position 2).
-
Connect wiring harness (A) between motor and wiring harness in car.
-
Reconnect battery ground lead. Test operation.
14. Start blower motor. Use hand to feel around adapter ring for air leakage. If leakage is present, seal with butyl tape.
15. Install control module bracket.
16. Install control module and connector.
17. Install side panel.
18. Install new soundproofing panel.