780 V6-2849cc 2.8L SOHC B280F (1987)
Reinforcing Protection of Backrest Wiring
The cables to the backrest must be equipped with protective hose.
Length of protecting hose: 200 - 250 mm (8 - 10 in.).
Driver's Seat
Two cables run to the backrest on the right-hand side and one cable runs to the left-hand side of the seat.
Passenger Seat
All three cables to the backrest run on the right-hand side of the seat.
Install Protective Hose
Install protective hose on the backrest cables. Carry out the installation on the underside of the seat, insert the protective hose in the backrest so that the
folding mechanism cannot wear the cable.
Two protective hoses must be installed per seat, the cable to the folding control should be installed in the one protective hose, the other two cables in the
second protective hose.
Install 3 tie straps on each protective hose as illustrated.
Install Edge Trim
