780 V6-2849cc 2.8L SOHC B280F (1987)
Use rubber plug P/N 941269-3.
Make a small hole and a cut in the rubber plug as illustrated.
Install rubber plug on cable.
Install rubber plug in the seat frame hole.
Turn the cut upwards (D).
Install Edge Trim on Panel Edges
Install edge trim on panel edges under the cables to the seat belt warning and control unit. Length of each trims, approximately 60 mm (2.4"), P/N
699856-1 (C).
Install Edge Trim on the Wire Matting
Use edge trim, P/N 699856-1.
The spring assembly is held in place by three coil springs on each side.
Measure and cut the edge trim, the edge trim must be installed between the coil springs so that they cover any sharp edges on the strands, see illustration.
Secure the wiring from seat belt buckle and control unit to edge trim on the spring assembly using tie straps.
