850 L5-2.3L Turbo VIN 57 B5234FT (1994)
Receiver Dryer: Service and Repair
Installation
WARNING: Before commencing work, See: Service Precautions
CAUTION: Before commencing work, read and observe general repair instructions, air conditioning (A/C) system. See: Service and Repair
NOTE:
-
When replacing receiver/dryer, always change O-rings in pipe and snap-on connections.
-
When Install Suction Pipe follow the same procedure.
-
When replacing receiver/dryer, fill the new receiver/dryer with 90 cm3 of fresh oil See "General Repair Instructions." See: Service and Repair
Installation:
-
Switch hose to new receiver/dryer, torque setting 30 Nm (22 ft lb).
-
Note that suction pipe position is relative to receiver/dryer.
-
Switch bracket. Use gauge 5473 for right position.
Install:
-
Receiver/dryer. Note, for snap-on connections, use new O-rings lubricated with compressor oil
-
Compressor pipe connections: torque setting (suction pipe) 60 Nm (44 ft lb). Use New O-rings here too.
-
Fill system with refrigerant and test for leaks. See: Service and Repair
-
Remove shield 5474.
Install:
-
Air guide.
-
Fan cover.
-
Relays and cables to tan cover.
-
Control unit box fresh air hoses and vents.
-
Control unit box diagnostic unit.
-
Air intake hose and vent.
-
Battery negative cable.