850 L5-2.4L VIN 55 B5254S (1993)
Headlamp Motor: Service and Repair
Removal
-
Turn ignition off.
-
Undo light control motor connectors.
-
Remove motor. Turn 1/4 turn anti-clockwise, motor is on bayonet fitting.
-
Pull motor backwards until motor shaft comes away from its mounting in the reflector.
Installation
-
Turn positioning screw on motor anti-clockwise until it sticks. This extends the motor shaft as far as it will go and makes installation easier.
-
Grease end of motor shaft.
-
Push on new motor.
-
Shorten rod until its bayonet fitting catches. Turn motor anti-clockwise as far as it will go.
-
Connect connectors.
-
Test light control motor.
-
Check light settings, adjust as necessary. See: Adjustments