850 L5-2.4L VIN 55 B5254S (1993)
^
Install / reconnect:
-
Knock sensor.
-
Knock sensor connector.
Tighten to 20 Nm (14.8 ft lb).
NOTE: Front Knock Sensor must be tightened in the 4 o'clock position and Rear Knock Sensor in the half-past five position.
Install Intake Manifold
^
Install:
-
New gasket with four lower intake manifold screws.
NOTE: Check that there are no foreign bodies in the intake manifold before installing it.
-
Intake manifold. Properly position the crankcase ventilation hose.
NOTE: Ensure that crankcase ventilation hose is not pinched between cylinder head and intake manifold when tightening.
-
Locate the EGR valve on the pipe.
Tighten EGR valve pipe coupling to 50 Nm (37 ft lbs).
-
Three upper intake manifold screws.
Tighten all screws to 20 Nm (15 ft lbs).
-
Support bracket.
-
Dipstick.
Install Fuel Rail
^
Install / reconnect:
-
All rubber damping elements on intake manifold.
-
Fuel rail and fuel pipe clips (two).
-
Use new bolts.
Tighten to 10 Nm (7.4 ft lbs) + 75°.