850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
- Resistance between tip of antenna and antenna lead terminal should be max. 1 when antenna is fully extended.
Inspection of Contact Strip
INSPECTION OF CONTACT STRIP
The following action should be taken if the antenna cannot be extended completely after cleaning, or if the antenna mast does not retract
completely into the antenna tube:
- Check if antenna motor is equipped with a contact strip as illustrated. If so, strip should be cut so that ends are separated by a gap of at least 3 mm.
- If strip is not cut, it should be cut at two points to provide a gap of at least 3 mm as illustrated. Do not slacken retaining screws.
Checking Control Module
CHECKING CONTROL MODULE
If antenna operation is still faulty following above action, control module should finally be checked.
- Disconnect module connector by depressing spring catch and pulling connector downward.
- Check operation of antenna with new control module, p/n 3533347-5.
- Control module must be replaced if faulty.