850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
Rear Door Limiter: All Technical Service Bulletins
Body - Repairing Loose Door Stops in A and B Posts
SECTION
8
GROUP
81
NO.
808
DATE
Aug. 1996
Reparing door stops A- and B-posts
REFERENCE: TP 3239512, SECTION 8 (81, 84) BODY AND GLASS; 850 1992-
This service bulletin supersedes earlier SB 81-808 dated July 1996 which can be discarded. The templates have been corrected.
Repairing loose door stops in A- and B-posts
This Service Bulletin describes how to repair damaged door stop welds.
Door stop mountings are available as replacement parts if a mounting needs replacing.
P/N: Door stop mounting A-post 6817408-5
Door stop mounting B-post 6817409-3
WARNING!
The use of protective equipment such as safety goggles is recommended.
Procedures for preventing electronic component damage while are welding:
1.
To avoid closed circuits remove the negative battery lead.
2.
To avoid ground potentials for different control units, place the welding ground lead as close as possible to the welding spot.
3.
If welding is to take place close to any control unit, one should remove the unit just to avoid the risk for heat damage.
Method, repairing door stop mounting in A-post
Preparations:
-
Disconnect negative battery lead
-
Remove front door
-
Mask the A-post to protect it from welding and grinding damage
-
Protect the interior of the car with a fireproof cover