850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
-
Remove the 4-pin connector connecting the hydraulic unit and combination relay.
-
Hang combinations relay up to prevent it coming into contact with brake fluid.
[NE6]
-
Remove nut holding hydraulic unit to bracket by shock absorber turret.
-
Undo the two nuts on the shock absorber turret and lift that mounting enough to allow the hydraulic unit bracket to be removed.
[NE7]
-
Remove the two brake hoses running to the brake fluid reservoir. One hose is difficult to get at, so it may be easier to remove it when lifting the
bracket out.
-
Lift bracket carefully out of the engine compartment, together with the suspended hydraulic unit, reducing valve and control module.
Removing hydraulic unit [NE8]
-
Cut tie band and remove coiled lead from bracket.
-
Remove the two brake pipes to the reducing valve.
-
Remove the four mounting bolts from the hydraulic unit.
-
Remove hydraulic unit.
NOTE: Hydraulic unit must be replaced as a complete unit. Never open hydraulic unit under any circumstances. Reassembling it calls for special
equipment and facilities.
Installing hydraulic unit [NE9]
