850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
Cleaning and checking [KF6]
NOTE: Cleaning is important to avoid lateral run-out in the brake disc.
-
Make sure that hub flange is clean. Remove rust with a steel blade and steel brush.
-
Brush off any dirt on pulse wheel and wheel sensor with a soft brush.
-
If hub is damaged, measure the hub lateral run-out as per KG. Measuring lateral run-out on hub. See: Testing and Inspection
Installing brake disc [KF7]
NOTE: Take care when handling the new brake disc. Careless handling can cause damage (e.g. warping).
-
Install new brake disc on hub.
-
Install locating pin and tighten to 8 Nm.
[KF8]
-
Install brake caliper with new bolts. Tighten to 60 Nm (45 ft.lb).
-
Install brake pipe in clips.
-
Install three-way connector mounting bolt, (LH brake caliper only).
Finishing [KF9]
- Go to KB6. See: Brake Pad/Service and Repair
