850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
Brake Rotor/Disc: Testing and Inspection
Measuring Lateral Run-Out In Hub [KG]
Special tools: 999 5418 measurement tool set 999 5507 set of screws
Preparations [KG1]
-
Get measurement tool set 999 5418.
-
Remove brake caliper and brake pads as per KE2-KE4 (front) or KF2-KF5 (rear). Then continue as below. See: Brake Caliper/Service and
Repair
NOTE: Mark brake disc up against hub so disc can return to its old position when installing.
[KG2]
-
Clean hub flange carefully. Remove rust with steel blade and steel brush.
Installing measurement equipment [KG3]
-
Install measurement equipment as per illustration. Illustration shows testing front.
-
Front: Use M8 bolts, washers and nuts in bolt set 999 5507 when installing measurement tool bracket to front brake caliper mounting hole.
NOTE: Make sure that bracket is not lying against driveshaft gaiter, (front only).
-
Rear: Use the bolts included in the measurement tool set when installing measurement tool bracket to the rear brake caliper mounting hole.
Measuring lateral run-out [KG4]
