850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
-
Put the test gauge point against the hub flange as in the illustration.
-
Rotate hub gently. Use a wheel wrench as an aid on the front hub.
NOTE: Illustration shows testing front.
-
Note test gauge run-out. Hub lateral run-out must not exceed 0.020 mm (0.00079").
-
Replace hub if maximum lateral run-out exceeds 0.020 mm (0.00079").
Front:
Replace hub.
Rear:
Replace hub.
Finishing [KG5]
-
Install brake disc on hub, lining up marks. Tighten locating pin and bolt to 8 Nm (6 ft.lb).
-
Go to KE7 (front) or KF8 (rear). See: Service and Repair