volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 4994 > < Diagram Information and Instructions|Page 4992
Page 1
background image

Electronic Brake Control Module: Service and Repair

Preparations [ND1]

-

Ignition off.

Removal [ND2]

-

Clean connector.

-

Remove connector.

-

Remove the three bolts and lift control

-

module carefully out of car.

Installation [ND3]

-

Install control module and tighten bolts to 5 Nm (4 ft.lb).

-

Install connector.

Operational checks [ND4]

-

Read off any DTCs posted in control module and erase them.

-

Quit DTM by switching off ignition.

Diagram Information and Instructions|Page 4994 > < Diagram Information and Instructions|Page 4992