850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
- evap-valve hose (turbo).
- Four screws for the electric fan shroud.
- air duct connected to the control module box.
- connectors for the fan (bend back shroud a little).
- inlet manifold and EGR-valve hoses (where applicable) (bend back shroud a little).
- Shroud spacer washers.
- fan and shroud.
Cover radiator with protective shield (p/n 9995474-5).
DISMANTLING WIRING CONDUIT
Remove:
- cover over solenoid.
- upper section of wiring conduit in order to expose complete fusible link cable.
REMOVAL OF FUSIBLE LINK CABLE
Remove:
- cable from starter motor.
- wire ties, by cutting them off.
- the old cable from the wiring conduit.
- the cable from the flexible wiring conduit.
- cable connector from connection above radiator (see inset).
Inspect remaining wiring in conduit for visual signs of insulation and/or wire strands that need repair.
Note:
SB 37-801 refers to sealed crimping sleeves to be used when repairing wires in the engine compartment.
Installation of Fan
INSTALLATION OF NEW FUSIBLE LINK CABLE IN WIRING CONDUIT