850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
normally used
MOUNTING FOR IDLER PULLEY
This section describes 4 types of plate with a mounting plate (A, B, C and D).
A1
A-TYPE
Mounting with round spacer and welded nut.
Note
This mounting bracket has been replaced during Recall 63 with B-type. Should you discover an A-type bracket, refer to SMB 21-63 and complete
Recall 63.
A2
B-TYPE
Mounting that lies edge-to-edge with the bracket's edge. The difference between this type and the C-type (see next page) is that the reinforcement is
thicker around the shaft hole than at the ends.
Replacement for A-type. Limited production use.
A3
C-TYPE