850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
Mounting with the center (arrowed) edge-to-edge with the bracket edge. Mounting has the same thickness around the shaft hole (center) as at the ends.
Pulley must be changed to H-type for use of this bracket.
A4
D-type
Mounting with center (arrowed) angled down from the bracket edge. Mounting is the same thickness around the shaft hole (center) as at the ends.
Tensioner must be changed to F-type for use of this bracket.
PROTECTIVE GUARD AT FLUID RESERVOIR FOR POWER STEERING.
This section describes differences between new and older types of protective guard at the power steering fluid reservoir and tightening order for the
protective guard screws.
The protective guard should only be replaced by the new type in combination with replacement of the mounting plate.
NEW TYPE
The protective guard is included in the replacement parts kit.
