850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
-
Detach connector from shutter motor for the floor/defroster shutter.
The shutter motor is in back of the glove compartment, as shown in illustration. Connect the connector on the cable harness to the disconnected
connector and to the shutter motor.
-
Install foam supplied with cable harness around the cable harness connector to prevent rattling.
B2
^
Remove control module and detach connector 4/30C according to Service Manual - operation BD, Connection and disconnection of test box.
Let the two long cables go along the existing cable harness to the control module. Use cable test to clamp the cable harnesses together.
-
Open the secondary locking on the connector 4/30C.
-
Attach cables to terminals 3 and 4 in the 10-pin connector 4,30C.
-
Close the secondary locking.
-
Connect connector to the control module.
-
Install the control module.
-
Test functions.
-
Replace all parts removed.
D1
SETTING END POSITION (CONTROL CODE 9-9-9)
Set the shutter motor end position when car has chassis number prior to: 854-149800 and 855-054500
