850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
D2
SETTINGS BEFORE ACTIVATION
-
Blower switch in MANUAL position, approx. half effect.
-
Recirculation ON.
-
Left temp. control setting MAX cooling, blue markings.
-
Right temp. control setting MAX heating, red markings.
-
Air flow selector set to point between Ventilation/Defrost
-
A/C switch can be in the ON/AUTO or OFF position (has no effect on calibration)
D3
ACTIVATE FUNCTION TEST 4
Self-adjusting of shutter motor end position.
-
Ignition on.
-
Press four times on the button (hold down approx. 1 Sec. for each press) The LED lights when Function test 4 is activated. If LED does not indicate
when button pressed:
^
Continue with Checking DTC BC according to the Service Manual
The control module can accept a command code when the LED is blinking.
^
Enter command code 99-9 according to Service Manual, entering codes BA5.
-
Press a series of nine short pushes on the button. Enter the series three times with a short pause after each series of nines, so the LED has time to
indicate again.
The control module is now activated to carry out self-adjustment of the shutter motor end positions.
-
Wait approx. 10 seconds so the blower motor has time to start.
-
Ignition off, to exit Function test 4.
-
Ignition on.
A/C and REC indicator LEDs on the control module are blinking.
- Continue to test driving the car at D6.
D4
CHECKING IF THE CONTROL MODULE IS ACTIVATED FOR SELF-ADJUSTMENT