850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
Figs. B,C & D
-
Turn Ignition off, lights off.
-
Replacing the bulbs on the RH side is easier if you remove the front air duct to the control module box ventilation pipe, unhook the diagnostic unit
and move it to one side (see Fig. A).
-
Turn cover anti-clockwise and remove cover from lamp to be replaced.
Removing Low Beam Lamp (Outer Bulb):
-
Press in spring clips, move them downwards and sideways and fold them down (see Fig. B). Applies to both LH and RH sides,
Removing Main Beam Lamp (Inner Bulb):
-
Press in spring clips, move them downwards and fold them to the side (see Fig. C). Always fold spring clips out towards the radiator.
-
Fit connector together, making sure that the flat pin does not come out of female contact, as this could cause poor contact and make the insulation
melt.
-
Insert bulb into place. Push bulb towards reflector and push in, and hook spring clip in.
Check that lamp is located correctly.
-
Refit cover. It will only screw in one way, with the word TOP at the top.
-
If working on the RH side, refit ventilation pipe and diagnostic unit (see Fig. A).
-
Test lamp to see if it lights up.
