850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
-
Lift the receiver/drier upwards where the bracket is hooked at the side member.
Removing the receiver / drier from the bracket:
-
When replacing the receiver / drier, the new unit must be filled with 90 cm3 of new oil. Refer to: "Heating and air Conditioning : Refrigerant
Oil : Service and Repair" See: Fluids/Refrigerant Oil/Service and Repair
-
Transfer the suction pipe to the new receiver/drier. Tighten to 30 Nm.
-
Note! Note the position of the suction pipe relative to the receiver / drier.
-
Transfer the bracket
-
Note! Model year 1992-1993: Use adjustment tool 999 5473 to establish the correct position.
Installation
Install:
-
Receiver/drier
-
Note! Always use new O-rings lubricated with compressor oil for the quick-release connectors.
-
Compressor pipe connection.
Model year 1992-1993: Tighten the suction pipe. Tighten to 60 Nm.
Model year 1994-: Tighten the suction pipe. Tighten to 25±6 Nm
-
Note! Use new O-rings here as well.
-
Fill the system with refrigerant. Check for leaks.
Install:
-
The air baffle
The fresh air intake hoses for the control module
-
The fresh air intake hoses for the control module box and the nozzle
-
The data link connector (DLC) on the control module box
-
The fresh air hose and nozzle
-
The battery negative lead.