850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
-
Install the press tool with screw and alignment washer (A) from the kit.
-
Pull off the threaded insert (B) by pulling the screw against the press tool.
-
Remove the threaded insert (B) from the tool and discard. Discard black washer (C) as well.
INSTALL NEW THREADED INSERT AND WASHER
-
Install new threaded insert and new black washer. Tighten threaded inserts and black washer with the bolt and washer from the kit. Tighten to 60 Nm
(45 ft.lbs).
-
Check that the flange of the threaded insert is in close contact with the seat rail.
BE SURE THAT THE THREADED INSERTS ARE INSTALLED FROM CORRECT SIDE, SEE PICTURE.
-
Remove the screw and alignment washer.
REINSTALL THE SEAT-BELT-CATCH
-
Tighten the bolt (Torx 50) to 40 Nm (30 ft.lbs).
REINSTALL THE SEAT
-
Reinstall the seat on guide lugs.
-
Install the 2 front bolts and torque to 40 Nm (30 ft. lbs.)
-
Install the front seat rail caps.