850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
NOTE: Clean around sensor carefully before removing it.
-
Remove sensor mounting bolt and extract sensor.
-
Remove wheel sensor leads.
-
Remove sensor.
Installing wheel sensors [NC4]
-
Clean sensor seat tree of dirt and rust so sensor ends up in right position relative to pulse wheel.
-
Brush any dirt off of pulse wheel. Use a soft brush.
-
Install sensor leads and sensor and tighten bolt to 10 Nm (8 ft.lb).
Installing wheel sensor connector [NC5]
-
Run a lead down through hole for level sensor and fuel pump to rear axle.
-
Attach new connector to lead.
NOTE: Protect connector from dirt and moisture.
-
Pull connector up alongside fuel hoses to the other connector.
-
Connect connector to wheel sensors. Install leads to opening.
Finishing [NC6]